Shipment Unboxing
Inspect the shipment for any damages to the outside box before releasing the driver. If a corner is crushed, whole in box, box not stapled to the pallet remove box from the grill. Inspect the grill for any damages. If you would not buy this grill refuse the shipment and send back with driver. Note it on the paperwork and take a picture of the paperwork with it noted and send to orders@smokinbrothers.com
HOW TO INSTALL CASTERS
Remove the casters from the plastic wrap. Make sure the rubber expansion is not already compressed. If so loosen the nuro nut by holding the stem and turning the caster clockwise. Slide the stem into the tubing of the grill and grab the dust cap and begin to turn counter clockwise to tighten the expansion adapter. When you can no longer turn by hand you can use an open ended ¾ inch wrench to tight the rest of the way or depress the brake and turn the whole wheel.
HOW TO INSTALL THE HEAT SHIELD
Traditional Models
-The shield has 4 angles welded in the bottom of the grill that heat shield should be placed inside of.
Premier Plus and Premier Models
-On the fire box coming from the front of the grill into the center of the grill area two brackets are welded to allow for the Heat shield to be slid in-between to hold in place.
HOW TO INSTALL THE DRIP PAN
The drip pan gets installed at an angle on the bracket on the left side of the grill and the grease trap on the right side of the grill. The small lip goes to the left bracket while the large lip goes to the grease trap area. Always remember not to go over the top of the sides of the pan with foil on the front and back. This may cause hot spots in your grill. Watch our Grill Maintenance Video or purchase our reusable drip liner for your grill.
HOW TO INSTALL FRONT & SIDE SHELVES
Adding shelves to your grill is a great way to increase your available workspace. Please refer to the following installation guides for Traditional and Premier Plus shelves.
Installing Shelves on Premier and Premier Plus Grills
HOW TO INSTALL GRID HOOKS
Premier Plus grills come with two hooks and mounting hardware. Please refer to the document below for installation instructions.
Installing Grid Hooks
GETTING STARTED: INITIAL BURN PROCESS
Check out this how-to video from Ryan on the easy initial burn on any grill with the Que-View controller.